News

What Are The Characteristics And Functions of The Led Controller

　　 Controllers are flooded with the whole industry. Different industry controllers can be different. This article mainly introduces LED controllers. Let’s take a look at the features of LED controllers.

　　Characteristics of LED controller:

Features 1. High reliability. It is not like a LED street light controller. It needs to be installed in a very high place. It is very inconvenient if you want to repair it during use, and it will increase the cost of repair. Use this device Can save such troubles.

Features 2. High efficiency. Since LEDs are energy-saving products, the efficiency of the controller must be improved. Of course, the heat dissipation structure of the equipment installed in the lamp is also very important. This equipment is not only efficient, but also consumes low power. Low heat, which can increase the service life of LED lamps.

　　The role of led controller:

In today’s industry market, the demand for this device is constantly increasing, mainly because it is the life support of LEDs. In the process of use, many people think that this device can be used as a general-purpose controller, but it is not. The functions and effects of each controller are different, so before you choose to use, you must clarify your scope and purpose of use to ensure that the final selection is appropriate.

　　The matters needing attention in designing waterproof led controller:

First of all, the use of a waterproof LED controller is great, and its existence can overcome the use of equipment in harsh environments. When choosing and designing this type of controller, you must pay attention to its reliability, especially LED street lights. Because of the high installation location and inconvenient maintenance of the controller, the reliability of the waterproof performance must be strong.

Secondly, the worst thing about the waterproof LED controller is the ability to resist surges, and the effect of resisting reverse voltage is not ideal. Therefore, during the design process, we must pay attention to the protection of this aspect, because the grid load is enabled. Induction and lightning strikes can cause various surges in the power grid system. However, these surges can cause very serious damage to the equipment. Therefore, it is necessary to make corresponding solutions to this problem when designing.

Finally, it is necessary to ensure the high power factor of the equipment. This factor is the basic requirement of the power grid for the load. Normally, there is no mandatory index, but the load of the same kind should not be too concentrated, otherwise it will pollute the power grid and affect the use of the equipment; This kind of equipment is an energy-saving product, so the efficiency will become very high. When designing, the equipment should be installed in the structure of the lamp.